Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT DOOR WINDOW FRAME MOULDING › 2017.08–2020.08
RM27T0E _59 Vehicle Exterior _053749 EXTERIOR PANELS / TRIM _0261308 FRONT DOOR WINDOW FRAME MOULDING A

EXTERIOR PANELS / TRIM  FRONT DOOR WINDOW FRAME MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

When installing the window frame moulding, heat the vehicle body and window frame moulding using a heat light.

Standard:
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)
Window Frame Moulding 20 to 30°C (68 to 86°F)




NOTICE:

Do not heat the vehicle body or window frame moulding excessively.


PROCEDURE

Hide 75756C 1.INSTALL FRONT DOOR REAR WINDOW FRAME MOULDING LH

a.

Clean the vehicle body surface.

i.

Using a heat light, heat the vehicle body surface.


ii.

Remove the double-sided tape from the vehicle body surface.


iii.

Wipe off any tape adhesive residue with cleaner.



b.

Install a new front door rear window frame moulding.

i.

Using a heat light, heat a new front door rear window frame moulding and the vehicle body surface.


ii.

Remove the peeling paper from the face of the front door rear window frame moulding.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



iii.

Attach the clip and double-sided tape to install the front door rear window frame moulding.

HINT:

Press the front door rear window frame moulding firmly to install it.




c.

Install a new door window frame moulding clip.


Hide 67862 2.INSTALL FRONT DOOR WEATHERSTRIP LH

a.

Attach the 3 clips to install the upper part of the front door weatherstrip.


Hide 75712B 3.INSTALL FRONT DOOR BELT MOULDING LH

Hide 68151D 4.INSTALL FRONT DOOR GLASS RUN LH

Hide 68102 5.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

Hide 87940 6.INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH

Hide 67832 7.INSTALL FRONT DOOR SERVICE HOLE COVER LH

Hide 68172A 8.INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH

Hide 67602 9.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 74611C 10.INSTALL ASSIST GRIP COVER LH

Hide 69298A 11.INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH

Hide 67492A 12.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

Hide 13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 86790C 14.ADJUST SIDE TELEVISION CAMERA ASSEMBLY (w/ Multi-terrain Monitor)

HINT:

Adjust the side television camera for the passenger side only.