Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Entry and Start System) › from 2017.08
RM27T0E _58 Vehicle Interior _053730 DOOR LOCK _0261039 WIRELESS DOOR LOCK CONTROL SYSTEM(w/o Entry and Start System) C

DOOR LOCK  WIRELESS DOOR LOCK CONTROL SYSTEM(w/o Entry and Start System)  B1242  Wireless Door Lock Tuner Circuit Malfunction  


DESCRIPTION

The door control receiver receives signals from the transmitter and sends these signals to the main body ECU. This DTC is stored when the applicable RDA signal cannot be received within 1 second of the PRG signal being output from the main body ECU (multiplex network body ECU).

DTC Code DTC Detection Condition Trouble Area Note
B1242 The applicable RDA signal cannot be received within 1 second of the PRG signal being output from the main body ECU.
·

Harness or connector

·

Door control receiver

·

Main body ECU (multiplex network body ECU)


for 5L-E

WIRING DIAGRAM

B488364E01
5.146,2.938 6.813,3.281 1.667,0.344 10 false Main Body ECU (Multiplex Network Body ECU) 2.375,2.969 4.042,3.313 1.667,0.344 10 false Door Control Receiver 2.344,2.813 4.01,3.156 1.667,0.344 10 false R26 5.135,2.771 6.802,3.115 1.667,0.344 10 false G64 5.323,1.563 5.854,1.75 0.531,0.188 10 false PRG 5.333,2.125 5.865,2.313 0.531,0.188 10 false RDA 3.552,2.01 4.083,2.198 0.531,0.188 10 false RDA 3.583,1.448 4.115,1.635 0.531,0.188 10 false PRG 3.135,1.052 3.667,1.24 0.531,0.188 10 false +B 5.063,1.438 5.594,1.625 0.531,0.188 10 false 25 5.063,1.99 5.594,2.177 0.531,0.188 10 false 26 3.979,1.448 4.51,1.635 0.531,0.188 10 false 3 3.99,2.021 4.521,2.208 0.531,0.188 10 false 2 2.438,2 2.969,2.188 0.531,0.188 10 false GND 2.26,2.01 2.792,2.198 0.531,0.188 10 false 1 1.667,1.469 2.198,1.656 0.531,0.188 10 false ECU-B 0.26,1.281 1.271,1.604 1.01,0.323 10 false from Battery 2.438,1.302 2.969,1.49 0.531,0.188 10 false +B 2.271,1.229 2.802,1.417 0.531,0.188 10 false 5

CAUTION / NOTICE / HINT

NOTICE:
·

Inspect the fuses for circuits related to this system before performing the following procedure.

·

When replacing the door control receiver, refer to the registration procedures.

Click hereVehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Entry and Start System)>REGISTRATION



PROCEDURE

2.CHECK FOR DTC

OK

NG

3.CHECK HARNESS AND CONNECTOR (DOOR CONTROL RECEIVER - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))
3.CHECK HARNESS AND CONNECTOR (DOOR CONTROL RECEIVER - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))
a.

Disconnect the R26 door control receiver connector.


b.

Disconnect the G64 main body ECU (multiplex network body ECU) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
R26-2 (RDA) - G64-26 (RDA) Always Below 1 Ω
R26-3 (PRG) - G64-25 (PRG)
R26-2 (RDA) or G64-26 (RDA) - Other terminals and body ground Always 10 kΩ or higher
R26-3 (PRG) or G64-25 (PRG) - Other terminals and body ground




OK

4.CHECK HARNESS AND CONNECTOR (DOOR CONTROL RECEIVER - BATTERY AND BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK HARNESS AND CONNECTOR (DOOR CONTROL RECEIVER - BATTERY AND BODY GROUND)
a.
U169656C01
1.229,1.354 1.052,1.844 false 2.208,1.354 2.354,1.844 false 0.719,1.844 1.073,2.031 0.354,0.188 10 false GND 2.313,1.844 2.531,2.031 0.219,0.188 10 false +B 0.146,0.063 0.344,0.25 0.198,0.188 10 false *a 0.49,1.125 0.844,1.313 0.354,0.188 10 false R26
*a Front view of wire harness connector
(to Door Control Receiver)


Disconnect the door control receiver connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
R26-1 (GND) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
R26-5 (+B) - Body ground Always 11 to 14 V




OK

5.REPLACE DOOR CONTROL RECEIVER

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

5.REPLACE DOOR CONTROL RECEIVER
a.

Temporarily replace the door control receiver with a new one.

Click hereVehicle Interior>DOOR LOCK>DOOR CONTROL RECEIVER (for 5 Door)>REMOVAL




NEXT

6.CLEAR DTC
7.CHECK FOR DTC

OK

END (DOOR CONTROL RECEIVER IS DEFECTIVE)

NG

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)