Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/o Multi-display) › from 2017.08
RM27T0E _56 Audio / Visual / Telematics _053722 PARK ASSIST / MONITORING _0261004 TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/o Multi-display) J

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/o Multi-display)  Back Sonar Sensor RH Circuit  


DESCRIPTION

The ultrasonic sensor sends and receives ultrasonic waves. Based on the received wave, the sensor calculates the approximate distance between the vehicle and obstacle and sends the distance value as a signal to the clearance warning ECU.

WIRING DIAGRAM

E132021E43
4.479,2.031 4.792,2.229 0.313,0.198 10 false U6 4.479,2.188 6.177,2.531 1.698,0.344 10 false No. 1 Ultrasonic Sensor (Rear Center Sensor RH) 1.115,2.042 1.427,2.24 0.313,0.198 10 false V6 1.115,2.188 2.74,2.552 1.625,0.365 10 false No. 1 Ultrasonic Sensor (Rear Center Sensor LH) 2.156,1.615 2.531,1.833 0.375,0.219 10 false EO 2.156,1.24 2.531,1.458 0.375,0.219 10 false SO 4.823,0.854 5.135,1.052 0.313,0.198 10 false BI 4.823,1.615 5.198,1.833 0.375,0.219 10 false EI 4.823,1.24 5.198,1.458 0.375,0.219 10 false SI 2.156,0.792 2.469,0.99 0.313,0.198 10 false BO 2.5,0.719 2.594,0.906 0.094,0.188 10 false 2 2.5,1.125 2.604,1.292 0.104,0.167 10 false 4 4.604,1.5 4.698,1.646 0.094,0.146 10 false 5 4.604,0.719 4.698,0.906 0.094,0.188 10 false 1 4.604,1.125 4.708,1.292 0.104,0.167 10 false 3 2.51,1.5 2.604,1.646 0.094,0.146 10 false 6 5.813,0.833 5.906,1.021 0.094,0.188 10 false 2 5.833,1.229 5.938,1.396 0.104,0.167 10 false 4 5.823,1.604 5.917,1.75 0.094,0.146 10 false 6 5.448,0.844 5.76,1.042 0.313,0.198 10 false BO 5.469,1.24 5.844,1.458 0.375,0.219 10 false SO 5.479,1.604 5.854,1.823 0.375,0.219 10 false EO

PROCEDURE

1.INSPECT NO. 1 ULTRASONIC SENSOR (REAR CENTER SENSOR RH)
a.
E310959E10
1.906,0.833 2.438,0.635 true 1.906,1.063 2.438,1.063 true 1.917,1.333 2.427,1.427 true 1.01,1.5 1.521,1.344 true 0.979,1.083 1.51,1.083 true 1.031,0.677 1.521,0.854 true 0.771,0.573 1.083,0.771 0.313,0.198 10 false BO 2.51,0.563 2.823,0.76 0.313,0.198 10 false BI 2.51,0.969 2.823,1.167 0.313,0.198 10 false SI 2.51,1.375 2.823,1.573 0.313,0.198 10 false EI 0.75,1 1.063,1.198 0.313,0.198 10 false SO 0.76,1.406 1.073,1.604 0.313,0.198 10 false EO

Remove the No. 1 ultrasonic sensor (rear center sensor RH) (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Rear)>REMOVAL).


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (BI) - 5 (EI) Always 10 kΩ or higher
1 (BI) - 2 (BO) Always 10 kΩ or higher
3 (SI) - 4 (SO) Always Below 1 Ω
5 (EI) - 6 (EO) Always Below 1 Ω




OK

2.CHECK HARNESS AND CONNECTOR (REAR CENTER SENSOR RH - REAR CENTER SENSOR LH)

NG

REPLACE NO. 1 ULTRASONIC SENSOR (REAR CENTER SENSOR RH)

2.CHECK HARNESS AND CONNECTOR (REAR CENTER SENSOR RH - REAR CENTER SENSOR LH)
a.

Disconnect the U6 No. 1 ultrasonic sensor (rear center sensor RH) connector.


b.

Disconnect the V6 No. 1 ultrasonic sensor (rear center sensor LH) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
U6-1 (BI) - V6-2 (BO) Always Below 1 Ω
U6-3 (SI) - V6-4 (SO) Always Below 1 Ω
U6-5 (EI) - V6-6 (EO) Always Below 1 Ω
U6-1 (BI) - Body ground Always 10 kΩ or higher
U6-3 (SI) - Body ground Always 10 kΩ or higher
U6-5 (EI) - Body ground Always 10 kΩ or higher




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR