The ultrasonic sensor sends and receives ultrasonic waves. Based on the received wave, the sensor calculates the approximate distance between the vehicle and obstacle and sends the distance value as a signal to the clearance warning ECU.
Remove the No. 1 ultrasonic sensor (rear corner sensor LH) (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Rear)>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (BI) - 5 (EI) | Always | 10 kΩ or higher |
| 1 (BI) - 2 (BO) | Always | 10 kΩ or higher |
| 3 (SI) - 4 (SO) | Always | Below 1 Ω |
| 5 (EI) - 6 (EO) | Always | Below 1 Ω |
OK
NG
Disconnect the V7 No. 1 ultrasonic sensor (rear corner sensor LH) connector.
Disconnect the I8 clearance warning ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| V7-1 (BI) - I8-12 (BOR) | Always | Below 1 Ω |
| V7-3 (SI) - I8-14 (SOR) | Always | Below 1 Ω |
| V7-5 (EI) - I8-13 (E1) | Always | Below 1 Ω |
| V7-1 (BI) - Body ground | Always | 10 kΩ or higher |
| V7-3 (SI) - Body ground | Always | 10 kΩ or higher |
| V7-5 (EI) - Body ground | Always | 10 kΩ or higher |
OK
NG