Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › SFI SYSTEM › from 2017.08
RM27T0E _51 Engine / Hybrid System _053657 1GR-FE ENGINE CONTROL _0260436 SFI SYSTEM C

1GR-FE ENGINE CONTROL  SFI SYSTEM  P144C  Open in Secondary Air Injection System Heater Control Circuit  P144D  Short in Secondary Air Injection System Heater Control Circuit  


DESCRIPTION

The ECM operates the AIR PMP HTR relay which causes the air pump heater to operate.

DTC No. DTC Detection Condition Trouble Area
P144C Open or short in the AIR PMP HTR relay circuit for 5 seconds (1 trip detection logic).
·

Open or short in AIR PMP HTR relay circuit

·

AIR PMP HTR relay

·

ECM


P144D Open or short in the AIR PMP HTR relay circuit for 5 seconds (1 trip detection logic).
·

Open or short in AIR PMP HTR relay circuit

·

AIR PMP HTR relay

·

ECM



WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses of circuits related to this system before performing the following inspection procedure.


HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.


PROCEDURE

1.INSPECT NO. 1 INTEGRATION RELAY (AIR PMP HTR RELAY)
a.

Inspect the NO. 1 integration relay (AIR PMP HTR relay)(See page Engine / Hybrid System>1GR-FE (ENGINE CONTROL)>RELAY>ON-VEHICLE INSPECTION).



OK

2.CHECK HARNESS AND CONNECTOR (ECM - AIR PMP HTR RELAY)

NG

REPLACE NO. 1 INTEGRATION RELAY

2.CHECK HARNESS AND CONNECTOR (ECM - AIR PMP HTR RELAY)
a.

Remove the No. 1 integration relay from the engine room relay block and junction block assembly.


b.

Disconnect the ECM connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance (Check for Open):
Tester Connection Condition Specified Condition
1T-11 - G56-30 (HAI1) Always Below 1 Ω


Standard Resistance (Check for Short):
Tester Connection Condition Specified Condition
1T-11 or G56-30 (HAI1) - Body ground Always 10 kΩ or higher



d.

Reinstall the AIR PMP HTR relay.


e.

Reconnect the ECM connector.



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR