The ECM detects the signal from the transfer L4 position switch.
This DTC indicates that the transfer L4 position switch remains on.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| P2773 | Transfer L4 position switch remains on while the vehicle is being driven under the following conditions for 1.8 seconds or more (1 trip detection logic):
(a) Output shaft speed is between 1000 and 3000 rpm. (b) Transfer position switch is in H4. |
·
Short in transfer L4 position switch circuit ·
Transfer system ·
ECM |
The ECM monitors the transfer case L4 position switch to determine when the transfer case L4 gears are engaged. If the transfer case L4 gears remain engaged under the following conditions, the ECM will conclude that there is a malfunction of the L4 position switch, illuminate the MIL and store the DTC:
The L4 switch indicates that the L4 transfer case gears are engaged.
The transfer position switch is in H4.
The transfer case output shaft speed is between 1000 and 3000 rpm.
The specified time period has elapsed.
Perform registration and/or initialization when parts related to the automatic transmission are replaced (See page Drivetrain>AC60F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM (for 1GD-FTV)>PRECAUTION).
After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
Turn the transfer position switch to H4.
Perform the D Position Shift Test in Road Test (See page Drivetrain>AC60F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM (for 1GD-FTV)>ROAD TEST).
Check for DTCs again (See page Drivetrain>AC60F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM (for 1GD-FTV)>DTC CHECK / CLEAR).
Disconnect the G53 4 wheel drive control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G53-16 (L4) - Body ground | Always | 10 kΩ or higher |
| *a | Front view of wire harness connector
(to 4 Wheel Drive Control ECU) |
OK
(See pageDrivetrain>VF4BM (TRANSFER / 4WD / AWD)>TRANSFER SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Disconnect the G53 4 wheel drive control ECU connector.
Disconnect the C152 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C152-12 (L4) - Body ground | Always | 10 kΩ or higher |
| *a | Rear view of wire harness connector
(to ECM) |
OK
NG