The ECM detects the signal from the transfer L4 position switch.
This DTC indicates that the transfer L4 position switch remains off.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| P2774 | Transfer L4 position switch remains off while the vehicle is being driven under the following conditions for 1.8 seconds or more (1 trip detection logic):
(a) Output shaft speed is between 1000 and 3000 rpm. (b) Transfer position switch is in L4L. |
·
Open in transfer L4 position switch circuit ·
Transfer system ·
ECM |
The ECM monitors the transfer case L4 position switch to determine when the transfer case L4 gears are engaged. If the transfer case H4 gears remain engaged under the following conditions, the ECM will conclude that there is a malfunction of the L4 position switch, illuminate the MIL and store the DTC:
The L4 switch indicates that the H4 transfer case gears are engaged.
The transfer position switch is in L4L.
The transfer case output shaft speed is between 1000 and 3000 rpm.
The specified time period has elapsed.
Refer to DTC P2773 (See pageDrivetrain>AC60F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM (for 2TR-FE)>P2773).
Perform registration and/or initialization when parts related to the automatic transmission are replaced (See page Drivetrain>AC60F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM (for 2TR-FE)>PRECAUTION).
After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
Turn the transfer position switch to L4L.
Drive the vehicle at 15 to 20 km/h (9 to 12 mph) for 1.8 seconds or more.
Check for DTCs again (See page Drivetrain>AC60F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM (for 2TR-FE)>DTC CHECK / CLEAR).
Disconnect the G53 4 wheel drive control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G53-16 (L4) - Body ground | Engine switch on (IG) | 11 to 14 V |
| *a | Front view of wire harness connector
(to 4 Wheel Drive Control ECU) |
OK
(See pageDrivetrain>VF4BM (TRANSFER / 4WD / AWD)>TRANSFER SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Disconnect the G53 4 wheel drive control ECU connector.
Disconnect the G180 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G53-16 (L4) - G180-25 (L4) | Always | Below 1 Ω |
OK
NG