Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster) › from 2017.08
RM27T0E _54 Brake _053712 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0260912 VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster)  C1268  Transfer L4 Position Switch Circuit  


DESCRIPTION

DTC Code DTC Detection Condition Trouble Area
C1268 The skid control ECU receives an L4 abnormal status signal from the four wheel drive control ECU via the CAN.
·

Transfer system

·

Skid control ECU (Brake actuator assembly)



CAUTION / NOTICE / HINT

NOTICE:

When replacing the skid control ECU (brake actuator assembly), perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster)>CALIBRATION).


PROCEDURE

1.INSPECT TRANSFER L4 SHIFT
a.

Shift the transfer to L4, and then drive the vehicle and check that there are no problems with the transfer system.

OK:

There are no problems with the transfer system.




OK

2.RECONFIRM DTC

NG

GO TO TRANSFER SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

2.RECONFIRM DTC

b.

Shift the transfer to L4, drive the vehicle, and then check for DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster)>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is output A
DTC is not output B



A

B