Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › from 2017.08
RM27T0E _54 Brake _053712 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0260910 ANTI-LOCK BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  C1420  Acceleration Sensor Malfunction  


DESCRIPTION

Refer to DTC C1419 (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>C1419).

DTC Code DTC Detection Condition Trouble Area
C1420 After the difference between GL1 and GL2 becomes 0.6 G or more with the vehicle stationary, the difference remains 0.4 G or more for 60 seconds or more.
·

Sensor installation

·

Acceleration sensor (Airbag sensor assembly)



CAUTION / NOTICE / HINT

NOTICE:

When replacing the acceleration sensor (airbag sensor assembly), perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>CALIBRATION).


HINT:

When DTC U0124 is output together with DTC C1420, inspect and repair the trouble areas indicated by DTC U0124 first (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>U0073).


PROCEDURE

1.CHECK AIRBAG SENSOR ASSEMBLY INSTALLATION
a.

Check that the acceleration sensor (airbag sensor assembly) is installed properly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>INSTALLATION).

OK:

The sensor is tightened to the specified torque.

The sensor is not installed at an angle.




OK

2.REPLACE AIRBAG SENSOR ASSEMBLY

NG

2.REPLACE AIRBAG SENSOR ASSEMBLY
a.

Replace the acceleration sensor (airbag sensor assembly) (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>REMOVAL).



NEXT

END