Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM WARNING BUZZER › 2017.08–2020.08
RM27T0E _58 Vehicle Interior _053736 PRE-CRASH SAFETY _0330261 PRE-CRASH SAFETY SYSTEM WARNING BUZZER A

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM WARNING BUZZER  REMOVAL  


PROCEDURE

Hide 28800 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page ).

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



Hide 2.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Hide 86652A 3.REMOVE SKID CONTROL BUZZER ASSEMBLY

a.
C212852C01
0.067,0.424 0.303,0.608 0.236,0.184 12 *A 0.05,2.883 0.288,3.066 0.238,0.184 12 *B
*A for LHD
*B for RHD


Detach the clamp and remove the skid control buzzer assembly.


b.

Disconnect the connector.