Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2017.08–2020.08
RM27T0E _51 Engine / Hybrid System _053696 CRUISE CONTROL _0260748 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P1630  Communication Error from VSC to ECM  


DESCRIPTION

The skid control ECU sends signals such as cruise control cancel signals and brake demand response signals to the ECM when the dynamic radar cruise control system is operating.

DTC No. Detection Item DTC Detection Condition Trouble Area
P1630 Communication Error from VSC to ECM While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating (vehicle-to-vehicle distance control mode), if communication data from the skid control ECU is logically inconsistent for approximately 0.5 seconds or more.
·

Communication circuit

·

Skid control ECU (brake actuator assembly)*1

·

Skid control ECU (master cylinder solenoid)*2

·

ECM



*1: for Vacuum brake booster

*2: for Hydraulic brake booster

CAUTION / NOTICE / HINT

NOTICE:
·

Before replacing the ECM, refer to Service Bulletin.

·

First check the CAN communication system by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed with troubleshooting.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/ Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING



PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Using the GTS, check that the CAN communication system is functioning normally.

OK:

CAN communication system is functioning normally.


HINT:

Refer to CAN Bus Check for the CAN communication system.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/ Central Gateway ECU)>DIAGNOSIS SYSTEM



Result:
Proceed to
OK
NG



OK

2.REPLACE SKID CONTROL ECU

NG

2.REPLACE SKID CONTROL ECU
a.

Replace the skid control ECU.

for Vacuum Brake Booster: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR>REMOVAL

for Hydraulic Brake Booster (for LHD): Click hereBrake>BRAKE SYSTEM (OTHER)>HYDRAULIC BRAKE BOOSTER(for LHD)>REMOVAL

for Hydraulic Brake Booster (for RHD):Click hereBrake>BRAKE SYSTEM (OTHER)>HYDRAULIC BRAKE BOOSTER(for RHD)>REMOVAL


Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTCs
3.CHECK FOR DTCs
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.



d.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.




Result:
Result Proceed to
DTC P1630 is not output A
DTC P1630 is output B



A

END

B