Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2017.08–2020.08
RM27T0E _51 Engine / Hybrid System _053696 CRUISE CONTROL _0260748 DYNAMIC RADAR CRUISE CONTROL SYSTEM J

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  Cruise SET Indicator Light Circuit  


DESCRIPTION

The ECM illuminates the cruise control SET indicator by sending indicator output demand signals to the combination meter assembly via CAN communication. The cruise control SET indicator illuminates when the dynamic radar cruise control system is controlling vehicle speed. The cruise SET indicator light circuit uses CAN communication. If the cruise control SET indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.

CAUTION / NOTICE / HINT

CAUTION:

Observe the following items for safety reasons when using GTS:

·

Before using the GTS, read the instruction GTS.

·

Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.

·

When driving the vehicle for testing purposes, 2 people are required. One person should operate the GTS while the other drives the vehicle.



NOTICE:
·

Before replacing the ECM, refer to Service Bulletin.

·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.



PROCEDURE

1.PERFORM ACTIVE TEST USING GTS (METER DISPLAY 1)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Perform the Active Test according to the display on the GTS.

w/ Multi-information Display:

Body Electrical > Combination Meter > Active Test

Tester Display Measurement Item Control Range Diagnostic Note
Meter Display 1 Multi-information display OFF or All -

OK:

The multi-information display turns on or off according to the operation of the Active Test.


w/o Multi-information Display:

Body Electrical > Combination Meter > Active Test

Tester Display Measurement Item Control Range Diagnostic Note
Indicat. SET SET indicator light OFF or ON -

OK:

Cruise control SET indicator light turns ON/OFF.



Result:
Proceed to
OK
NG



OK

2.READ VALUE USING GTS (-SET SWITCH)

NG

2.READ VALUE USING GTS (-SET SWITCH)
a.

Turn the dynamic radar cruise control system on using the cruise control switch (ON-OFF).


b.

Drive at a speed approximately 50 km/h (31 mph) or more.


c.

Enter the following menus: Powertrain / Radar Cruise1 / Data List.


d.

Read the Data List according to the display on the GTS.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DATA LIST / ACTIVE TEST

Powertrain > Radar Cruise1 > Data List

Tester Display Measurement Item Range Normal Condition Diagnostic Note
-SET Switch -SET switch status ON or OFF ON: -SET switch on
OFF: -SET switch off
-


Result:
Result Proceed to
The cruise control SET indicator illuminates and turns off according to the operation of the cruise control switch (-SET switch). A
The cruise control SET indicator does not illuminate but the Data List item -SET Switch changes according to the operation of the cruise control switch (-SET switch). B
The cruise control SET indicator does not illuminate and the Data List item -SET Switch does not change according to the operation of the cruise control switch (-SET switch). C



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPLACE COMBINATION METER ASSEMBLY

C