Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › from 2017.08
RM27T0E _54 Brake _053712 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0260910 ANTI-LOCK BRAKE SYSTEM D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  DIAGNOSIS SYSTEM  


DESCRIPTION


When troubleshooting a vehicle with the diagnosis system, the only difference from the usual troubleshooting procedure is connecting the GTS to the vehicle and reading various data output from the vehicle's skid control ECU.

The skid control ECU (brake actuator assembly) stores DTCs when the ECU detects a malfunction in the ECU itself or in its circuits.

To check the DTCs, connect the GTS to the DLC3 of the vehicle. The GTS enables you to clear the DTCs, activate various actuators, and check the Freeze Frame Data and Data List.

a.

Check the battery voltage.

Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge the battery before proceeding to the next step.



DIAGNOSIS


a.

If the skid control ECU (brake actuator assembly) detects a malfunction, the ABS warning light and brake warning light come on in order to warn the driver.


b.

DTCs are simultaneously stored in memory. Output DTCs can be read by connecting the GTS (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR).

NOTICE:

If parts connected to the IG terminal circuit are damaged due to high voltage, DTCs may not be able to be output from the ABS warning light and slip indicator light by connecting SST to the DLC3. In this case, inspect the IG power source circuit.



c.

This system has a test mode (signal check) function (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>TEST MODE PROCEDURE).



WARNING LIGHT INITIAL CHECK


a.

Release the parking brake.

NOTICE:

When releasing the parking brake, set chocks to prevent the vehicle from rolling.


HINT:

When the parking brake is applied or the level of the brake fluid is low, the brake warning light comes on.



b.

When the ignition switch is turned to ON, check that the ABS warning light and brake warning light come on for approximately 3 seconds.

HINT:

If the warning light check result is not normal, proceed to troubleshooting for the ABS warning light and brake warning light circuits.

If an indicator remains on or does not come on, proceed to troubleshooting for the light circuits listed below.


Trouble Area See procedure
ABS warning light circuit (Remains on) (Click here)
ABS warning light circuit (Does not come on) (Click here)
Brake warning light circuit (Remains on) (Click here)
Brake warning light circuit (Does not come on) (Click here)