Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM › from 2017.08
RM27T0E _56 Audio / Visual / Telematics _053722 PARK ASSIST / MONITORING _0261011 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1AC2  Slave Module Horizontal Axis Misalignment  


DESCRIPTION

This DTC is stored when the angle of the blind spot monitor sensor RH deviates more than the allowable range from the horizontal axis.

HINT:

If drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitorsystem on, the blind spot monitor system may store this DTC by mistake.


DTC Code DTC Detection Condition Trouble Area
C1AC2 When the blind spot monitor sensor deviates 5 degrees or more from the horizontal axis when the system is activated. Blind spot monitor sensor RH

CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor system is on.


PROCEDURE

1.CHECK INSTALLATION CONDITION
a.

Check the installation condition of the blind spot monitor sensor RH (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK).

HINT:

Take the appropriate action in accordance with the result.




NEXT

2.PERFORM BEAM AXIS CONFIRMATION
2.PERFORM BEAM AXIS CONFIRMATION
a.

b.

Perform Blind Spot Monitor Beam Axis Confirmation using the GTS (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK).

OK:

Blind Spot Monitor Beam Axis Confirmation performs normally.




OK

END

NG