| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0100/71 | While driving at 19 mph (30 km/h), the ECM indicates a CAN communication stop for 3 seconds or more. | CAN communication system |
| U0122/71 | The skid control ECU indicates a CAN communication stop for 3 seconds or more. | CAN communication system |
| U0124/71 | The yaw rate and acceleration sensor indicates a CAN communication stop for 3 seconds or more. | CAN communication system |
| U0126/71 | The steering sensor indicates a CAN communication stop for 3 seconds or more. | CAN communication system |
Clear the DTCs (See page Suspension>SUSPENSION CONTROL>KINETIC DYNAMIC SUSPENSION SYSTEM>DTC CHECK / CLEAR).
Perform a road test.
Check for DTCs (See page Suspension>SUSPENSION CONTROL>KINETIC DYNAMIC SUSPENSION SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
If a CAN communication malfunction DTC and a related sensor malfunction DTC are output at the same time, the CAN communication malfunction must be repaired before troubleshooting the sensor malfunction DTC.
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B