Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
74616C
3.REMOVE FRONT NO. 1 ASSIST GRIP PLUG LH
74611F
4.REMOVE NO. 1 ASSIST GRIP
62212
5.REMOVE FRONT PILLAR GARNISH LH
86160J
6.REMOVE FRONT NO. 3 SPEAKER ASSEMBLY
Disconnect the connector.
Detach the clip and claw and remove the front No. 3 speaker.