Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION ECU › from 2020.08
RM27T0E _56 Audio / Visual / Telematics _053721 NAVIGATION / MULTI INFO DISPLAY _0260990 NAVIGATION ECU A

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION ECU  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 86841 1.INSTALL NAVIGATION ECU

a.
E446371

Insert the navigation ECU as shown in the illustration.


b.

Install the navigation ECU with the 8 screws.

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


Hide 86842 2.INSTALL NAVIGATION WIRE NO.1

a.

Connect the 3 connectors to install the No. 1 navigation wire.


Hide 3.INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH NAVIGATION ECU

a.

Connect each connector.


b.
E446405

Insert the radio and display receiver assembly with navigation ECU and attach the 2 guides, 7 clips on the backside of the radio and display receiver assembly with navigation ECU.

NOTICE:

When inserting the receiver, do not press the knobs on it.



c.

Install the radio and display receiver assembly with navigation ECU with the 4 bolts.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


Hide 84010A 4.INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 6. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART