Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
55401E
3.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
55843A
4.REMOVE NO. 1 HEATER TO REGISTER DUCT
55844
5.REMOVE NO. 2 HEATER TO REGISTER DUCT
55971C
6.REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT
55972C
7.REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT
55950G
8.REMOVE DEFROSTER NOZZLE ASSEMBLY
86860
9.REMOVE NAVIGATION ANTENNA ASSEMBLY
Detach the 2 clamps.
Remove the 2 screws and navigation antenna assembly.