Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
67492A
3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
69298A
4.REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH
74611C
5.REMOVE ASSIST GRIP COVER LH
67602
6.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
68172A
7.REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH
67832
8.REMOVE FRONT DOOR SERVICE HOLE COVER LH
68102
9.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH
68151D
10.REMOVE FRONT DOOR GLASS RUN LH
67404F
11.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH
69217F
12.REMOVE FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY
69040A
13.REMOVE FRONT DOOR LOCK ASSEMBLY LH
Disconnect the connector.
| *A | w/o Double Locking System |
| *B | w/ Double Locking System |
|
Slide |
Using a T30 "TORX" wrench, remove the 3 screws.
Slide the front door lock assembly downward, pull out the front door lock open rod from the outside handle frame, and remove the front door lock assembly and cables as a unit.
Remove the front door lock open rod from the front door lock assembly.
Remove the door lock wiring harness seal from the front door lock assembly.
69720B
14.REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
69760C
15.REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH