Home › Vehicle Interior › DOOR LOCK › FRONT DOOR LOCK › from 2020.08
RM27T0E _58 Vehicle Interior _053730 DOOR LOCK _0261040 FRONT DOOR LOCK A

DOOR LOCK  FRONT DOOR LOCK  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 69760C 1.INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH

Hide 69720B 2.INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

Hide 69040A 3.INSTALL FRONT DOOR LOCK ASSEMBLY LH

NOTICE:
·

When reusing the removed front door lock assembly, replace the door lock wiring harness seal on the connector with a new one.

·

Do not allow grease or dust to adhere to the surface of the connector which contacts the door lock wiring harness seal.

·

Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may allow water into the connection. This may result in a malfunction of the front door lock assembly.



a.

Apply MP grease to the sliding parts of the front door lock assembly.


b.

Install a new door lock wiring harness seal to the front door lock assembly.


c.
B237873C01
0.052,0 0.542,0.344 0.49,0.344 12 false *A 0.052,2.042 0.583,2.469 0.531,0.427 12 false *B
*A w/o Double Locking System
*B w/ Double Locking System
V100135

Slide


Insert the front door lock open rod to the front door lock assembly.


d.

Check that the front door lock open rod is securely connected to the front door lock assembly.


e.

Using a T30 "TORX" wrench, install the front door lock assembly with the 3 screws.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


f.

Connect the connector.


Hide 69217F 4.INSTALL FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY

Hide 67404F 5.INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH

Hide 68151D 6.INSTALL FRONT DOOR GLASS RUN LH

Hide 68102 7.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

Hide 67832 8.INSTALL FRONT DOOR SERVICE HOLE COVER LH

Hide 68172A 9.INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH

Hide 67602 10.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 74611C 11.INSTALL ASSIST GRIP COVER LH

Hide 69298A 12.INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH

Hide 67492A 13.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

Hide 14.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 15. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART


Hide 16.CHECK SRS WARNING LIGHT