Home › Vehicle Interior › METER / GAUGE / DISPLAY › COMBINATION METER › from 2020.08
RM27T0E _58 Vehicle Interior _053733 METER / GAUGE / DISPLAY _0261081 COMBINATION METER A

METER / GAUGE / DISPLAY  COMBINATION METER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM

a.

Disable the auto tilt away function by changing the customize parameter

Click hereSteering>STEERING COLUMN>POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM>CUSTOMIZE PARAMETERS

NOTICE:

Record the current customize parameter setting (whether the auto tilt away function is enabled or disabled) in order to restore the current setting after finishing the operation.



b.

Turn the ignition switch to ON. Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.


Hide 2. PRECAUTION

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 55471A 4.REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)

Hide 55476C 5.REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)

Hide 55480D 6.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

Hide 55404D 7.REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

a.

except 5L-E:

i.
B488146C01
0,0 0,0 false
V100155

Protective Tape


Place protective tape as shown in the illustration.


ii.

Detach the 4 claws.


iii.
B488147

Detach the 4 claws.


iv.

Detach the 2 clips and 2 guides.


v.

Disconnect the connector and remove the instrument cluster finish panel sub-assembly.



b.

for 5L-E:

i.
B449248C01
0,0 0,0 false
V100155

Protective Tape


Place protective tape as shown in the illustration.


ii.

Detach the 4 claws.


iii.
B486258

Detach the 4 claws.


iv.

Detach the 2 clips and 2 guides.


v.

Disconnect the connector and remove the instrument cluster finish panel sub-assembly.



Hide 83100 8.REMOVE COMBINATION METER ASSEMBLY

a.
E194816

Remove the 4 screws and combination meter assembly.


b.

Disconnect the 2 connectors.