Home › Vehicle Interior › METER / GAUGE / DISPLAY › COMBINATION METER › from 2020.08
RM27T0E _58 Vehicle Interior _053733 METER / GAUGE / DISPLAY _0261081 COMBINATION METER A

METER / GAUGE / DISPLAY  COMBINATION METER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 83100 1.INSTALL COMBINATION METER ASSEMBLY

a.

Connect the 2 connectors.


b.

Install the combination meter assembly with the 4 screws.


Hide 55404D 2.INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

a.

except 5L-E:

i.

Connect the connector.


ii.

Attach the 2 clips and 2 guides.


iii.

Attach the 4 claws.


iv.

Attach the 4 claws to install the instrument cluster finish panel sub-assembly.



b.

for 5L-E:

i.

Connect the connector.


ii.

Attach the 2 clips and 2 guides.


iii.

Attach the 4 claws.


iv.

Attach the 4 claws to install the instrument cluster finish panel sub-assembly.



Hide 55480D 3.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

Hide 55476C 4.INSTALL INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)

Hide 55471A 5.INSTALL INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 7. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM

a.

Reset the auto tilt away function setting to the previous condition by changing the customize parameter.

Click hereSteering>STEERING COLUMN>POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM>CUSTOMIZE PARAMETERS


Hide 8. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART