Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
28800
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
55401E
3.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Remove the instrument panel safety pad sub-assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL).
82142A
4.REMOVE NO. 2 INSTRUMENT PANEL WIRE
Disconnect the connector.
When handling the airbag connector, take care not to damage the airbag wire harness.
Detach the clamp and remove the wire.
73960A
5.REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
Remove the 2 screws.
Detach the 5 hooks (A).
| *a | Hook A |
| *b | Hook B |
Detach the 5 hooks (B) and remove the instrument panel passenger airbag.