Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
73960A
1.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
Attach the 5 hooks (A).
| *a | Hook A |
| *b | Hook B |
Attach the 5 hooks (B) to install the instrument panel passenger airbag.
Install the 2 screws.
82142A
2.INSTALL NO. 2 INSTRUMENT PANEL WIRE
Attach the clamp to install the wire.
Connect the connector.
When handling the airbag connector, take care not to damage the airbag wire harness.
55401E
3.INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Install the instrument panel safety pad sub-assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>INSTALLATION).
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
6.CHECK SRS WARNING LIGHT
Check the SRS warning light (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSIS SYSTEM).