Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.INSTALL FRONT SEAT ASSEMBLY
Place the front seat assembly in the cabin.
Be careful not to damage the vehicle body.
Connect the seat wire connectors under the seat.
Temporarily install the front seat assembly with the 4 bolts.
Connect the cable to the negative (-) battery terminal.
Operate the power seat switch to move the seat to the rearmost position.
Tighten the 2 bolts in the order indicated in the illustration.
Operate the power seat switch to move the seat to the foremost position.
Tighten the 2 bolts in the order indicated in the illustration.
72138B
2.INSTALL SEAT TRACK COVER LH
Move the seat track cover LH in the direction of the arrow to attach the 4 guides.
Attach the 2 claws to install the seat track cover LH.
72158
3.INSTALL INNER SEAT TRACK BRACKET COVER LH
Move the inner seat track bracket cover LH in the direction of the arrow to attach the 2 guides.
Attach the 2 claws to install the inner seat track bracket cover LH.
72124
4.INSTALL FRONT SEAT OUTER TRACK BRACKET COVER LH
Operate the power seat switch to move the seat to the rearmost position.
Move the front seat outer track bracket cover LH in the direction of the arrow to attach the 2 claws and guide.
Attach the 2 claws to install the front seat outer track bracket cover LH.
72128A
5.INSTALL FRONT SEAT INNER TRACK BRACKET COVER LH
Move the front seat inner track bracket cover LH in the direction of the arrow to attach the 2 guides.
Attach the 2 claws to install the front seat inner track bracket cover LH.
71910A
6.INSTALL FRONT SEAT HEADREST ASSEMBLY
Install the front seat headrest assembly.
7. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
8.CHECK SRS WARNING LIGHT
Check the SRS warning light (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSIS SYSTEM).
9.INSPECT FRONT SEAT ASSEMBLY
w/ Memory:
Check the power seat operation (See page Vehicle Interior>SEAT>FRONT POWER SEAT CONTROL SYSTEM (w/ Memory)>OPERATION CHECK).
w/o Memory:
Check the power seat operation (See page Vehicle Interior>SEAT>FRONT POWER SEAT CONTROL SYSTEM(w/o Memory)>OPERATION CHECK).
w/ Seat Heater System:
Check the seat heater operation.
Turn the ignition switch to ON.
Turn the seat heater switch on.
Wait 5 minutes or more and confirm that the seat surface becomes warm.