Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
28800
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
67920
3.REMOVE DOOR SCUFF PLATE ASSEMBLY LH
62312B
4.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Partially remove the front door opening trim weatherstrip so that the lower center pillar garnish and center pillar garnish can be removed (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>REMOVAL).
58371F
5.REMOVE REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)
67934
6.REMOVE INSIDE QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)
67918D
7.REMOVE REAR DOOR SCUFF PLATE LH
62332C
8.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
Partially remove the rear door opening trim weatherstrip so that the lower center pillar garnish and center pillar garnish can be removed (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>REMOVAL).
73233
9.REMOVE OUTER LAP BELT ANCHOR COVER
62414A
10.REMOVE LOWER CENTER PILLAR GARNISH LH
Remove the bolt and floor anchor of the front seat outer belt assembly LH.
Detach the 4 claws, 2 clips and remove the lower center pillar garnish LH.
74638
11.REMOVE NO. 2 ASSIST GRIP PLUG LH
74611G
12.REMOVE NO. 2 ASSIST GRIP
62412
13.REMOVE CENTER PILLAR GARNISH LH
73220
14.REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH
Remove the nut and shoulder anchor of the front seat outer belt assembly LH.
Disconnect the pretensioner connector as shown in the illustration.
Remove the bolt and front seat outer belt assembly LH.
73200A
15.REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
Remove the 2 bolts and front shoulder belt anchor adjuster assembly.