Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
67920
3.REMOVE DOOR SCUFF PLATE ASSEMBLY LH
62312B
4.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Partially remove the front door opening trim weatherstrip so that the deck trim side panel assembly LH can be removed (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>REMOVAL).
64910M
5.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
58649C
6.REMOVE MAT SET PLATE COVER
58574A
7.REMOVE REAR FLOOR MAT REAR SUPPORT PLATE
62538C
8.REMOVE QUARTER TRIM COVER HOLE LH
58570C
9.REMOVE REAR FLOOR CARPET ASSEMBLY
64725D
10.REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
64937A
11.REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/ o Tonneau Cover)
64712F
12.REMOVE FRONT DECK SIDE TRIM COVER (w/ Tonneau Cover)
73233
13.REMOVE OUTER LAP BELT ANCHOR COVER
64740C
14.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
Remove the bolt and floor anchor of the front seat outer belt assembly LH.
Remove the bolt and floor anchor of the rear No. 1 seat outer belt assembly LH.
Remove the 3 bolts and 2 screws.
Detach the 9 claws and 12 clips and remove the deck trim side panel assembly LH.
62520P
15.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH
73220
16.REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH
Remove the nut and shoulder anchor of the front seat outer belt assembly LH.
Disconnect the pretensioner connector as shown in the illustration.
Remove the bolt and front seat outer belt assembly LH.
73200A
17.REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
Remove the 2 bolts and front shoulder belt anchor adjuster assembly.