Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
67492A
3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
69298A
4.REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH
74611C
5.REMOVE ASSIST GRIP COVER LH
67602
6.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
68172A
7.REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH
86160
8.REMOVE FRONT NO. 1 SPEAKER ASSEMBLY
67832
9.REMOVE FRONT DOOR SERVICE HOLE COVER LH
68102
10.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH
69802
11.REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
85720C
12.REMOVE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
Using a T25 "TORX" socket wrench, remove the 3 screws and the front power window regulator motor assembly LH.
| *1 | Spring | - | - |
| *a | Range of Movement | - | - |
Do not place your finger, etc. within the range of movement of the front door window regulator sub-assembly LH. When removing the front power window regulator motor assembly LH, the force of the spring causes the front door window regulator sub-assembly LH to move in the direction of the arrow shown in the illustration (the direction in which the window rises), which may cause injury.
Be careful when removing the screws as the motor may fall and become damaged.