Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
When removing the window frame moulding, heat the vehicle body and window frame moulding using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Window Frame Moulding | 20 to 30°C (68 to 86°F) |
Do not heat the vehicle body or window frame moulding excessively.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
67492A
3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
69298A
4.REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH
74611C
5.REMOVE ASSIST GRIP COVER LH
67602
6.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
68172A
7.REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH
67832
8.REMOVE FRONT DOOR SERVICE HOLE COVER LH
87940
9.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH
68102
10.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH
68151D
11.REMOVE FRONT DOOR GLASS RUN LH
75712B
12.REMOVE FRONT DOOR BELT MOULDING LH
67862
13.REMOVE FRONT DOOR WEATHERSTRIP LH
Detach the 3 clips and remove the upper part of the front door weatherstrip LH so that the front door rear window frame moulding LH can be removed.
75756C
14.REMOVE FRONT DOOR REAR WINDOW FRAME MOULDING LH
Remove the door window frame moulding clip.
|
Protective Tape |
| *a | Double-sided Tape |
| *b | Moulding Remover |
Put protective tape around the front door rear window frame moulding LH.
Using a moulding remover, detach the clip and remove the double-sided tape to remove the front door rear window frame moulding LH.