Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
When installing the window frame moulding, heat the vehicle body and window frame moulding using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Window Frame Moulding | 20 to 30°C (68 to 86°F) |
Do not heat the vehicle body or window frame moulding excessively.
75756C
1.INSTALL FRONT DOOR REAR WINDOW FRAME MOULDING LH
Clean the vehicle body surface.
Using a heat light, heat the vehicle body surface.
Remove the double-sided tape from the vehicle body surface.
Wipe off any tape adhesive residue with cleaner.
Install a new front door rear window frame moulding LH.
Using a heat light, heat a new front door rear window frame moulding LH and the vehicle body surface.
Remove the peeling paper from the face of the front door rear window frame moulding LH.
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
Attach the clip and double-sided tape to install the front door rear window frame moulding LH.
Press the front door rear window frame moulding LH firmly to install it.
Install a new door window frame moulding clip.
67862
2.INSTALL FRONT DOOR WEATHERSTRIP LH
Attach the 3 clips to install the upper part of the front door weatherstrip LH.
75712B
3.INSTALL FRONT DOOR BELT MOULDING LH
68151D
4.INSTALL FRONT DOOR GLASS RUN LH
68102
5.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH
87940
6.INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH
67832
7.INSTALL FRONT DOOR SERVICE HOLE COVER LH
68172A
8.INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH
67602
9.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
74611C
10.INSTALL ASSIST GRIP COVER LH
69298A
11.INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH
67492A
12.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH
13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
14. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
86790C
15.ADJUST SIDE TELEVISION CAMERA ASSEMBLY (w/ Multi-terrain Monitor)
Adjust the side television camera.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>CALIBRATION