Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR WINDOW FRAME MOULDING › from 2020.08
RM27T0E _59 Vehicle Exterior _053749 EXTERIOR PANELS / TRIM _0261309 REAR DOOR WINDOW FRAME MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR WINDOW FRAME MOULDING  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

When removing the window frame moulding, heat the vehicle body and window frame moulding using a heat light.



Standard:
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)
Window Frame Moulding 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the vehicle body or window frame moulding excessively.


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 69298C 3.REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH

Hide 74611C 4.REMOVE ASSIST GRIP COVER LH

Hide 67604 5.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 68174A 6.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH

Hide 67842E 7.REMOVE REAR DOOR SERVICE HOLE COVER LH

Hide 68152C 8.REMOVE REAR DOOR GLASS RUN LH

Hide 67408E 9.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

Hide 68124B 10.REMOVE REAR DOOR QUARTER WINDOW GLASS LH

Hide 68104 11.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

Hide 75722A 12.REMOVE REAR DOOR BELT MOULDING LH

Hide 67872 13.REMOVE REAR DOOR WEATHERSTRIP LH

a.
B236341

Detach the clip and remove the upper part of the rear door weatherstrip LH so that the rear door front window frame moulding LH can be removed.


Hide 75762A 14.REMOVE REAR DOOR FRONT WINDOW FRAME MOULDING LH

a.
B243913

Remove the door window frame moulding clip.


b.
B243912C03
0.771,1.188 1.01,1.188 1.01,1.188 1.208,1.281 true 1.135,1.76 0.656,1.76 true 1.417,1.927 1.75,1.927 true 0.438,1.677 0.604,1.854 0.167,0.177 10 false *a 1.792,1.844 1.958,2.021 0.167,0.177 10 false *a 0.563,1.115 0.74,1.26 0.177,0.146 10 false *b
V100155

Protective Tape
*a Double-sided Tape
*b Moulding Remover


Put protective tape around the rear door front window frame moulding LH.


c.

Using a moulding remover, detach the clip and remove the double-sided tape to remove the rear door front window frame moulding LH.