Each unit of the audio and visual system connected to the AVC-LAN (communication bus) transmits signals via AVC-LAN communication.
If a short to +B or short to ground occurs in an AVC-LAN communication line, the audio and visual system will not function normally because communication is not possible.
The radio and display receiver assembly is the master unit.
Remove the radio and display receiver assembly.
| *a | Component without harness connected
(Radio and Display Receiver Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H92-5 (TX1+) - H92-6 (TX1-) | Always | 60 to 80 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL
Disconnect the H92 radio and display receiver assembly connector.
Disconnect the H105 stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H105-8 (TX+) - H92-5 (TX1+) | Always | Below 1 Ω |
| H105-7 (TX-) - H92-6 (TX1-) | Always | Below 1 Ω |
| H105-8 (TX+) - Body ground | Always | 10 kΩ or higher |
| H105-7 (TX-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect and reconnect each slave unit one by one until the master unit returns to normal.
Check all slave units.
If disconnecting a slave unit causes the master unit to return to normal, the slave unit is defective and should be replaced.
Master unit returns to normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL