Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM › from 2020.08
RM27T0E _51 Engine / Hybrid System _053696 CRUISE CONTROL _0332058 LANE DEPARTURE ALERT SYSTEM Y

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS
2.CUSTOMER PROBLEM ANALYSIS
HINT:
·

In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.

·

Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

·

The following 5 items are important points for problem analysis:

What Vehicle model, system name
When Date, time, occurrence frequency
Where Road conditions
Under what conditions? Driving conditions, weather conditions
How did it happen? Problem symptoms



Result:
Proceed to
NEXT



NEXT

3.BASIC INSPECTION
3.BASIC INSPECTION
a.

Check the battery voltage.

Standard voltage:

11 to 14 V


HINT:

If the battery voltage is below 11 V, recharge or replace the battery before proceeding to the next step.



b.

While using the parts location and circuit diagrams as a reference, inspect areas which can be visually inspected for blown fuses, problems with wire harnesses (open and short circuits), improperly connected connectors, etc.


Result:
Proceed to
NEXT



NEXT

4.CHECK CAN COMMUNICATION SYSTEM
4.CHECK CAN COMMUNICATION SYSTEM
a.

Using the GTS, perform CAN bus diagnostics and check that there are no malfunctions in ECUs connected to the CAN communication system.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/ Central Gateway ECU)>DIAGNOSIS SYSTEM


Result:
Result Proceed to
Normal A
Abnormal B



A

5.CHECK FOR DTC

B

5.CHECK FOR DTC
a.

Check for DTCs.


b.

Make a note of any DTCs that are output.


Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

6.CHECK VEHICLE CONTROL HISTORY

B

7.RECHECK FOR DTC
6.CHECK VEHICLE CONTROL HISTORY
a.

Using the GTS, check for vehicle control history.


b.

Record any output vehicle control history.


Result:
Result Proceed to
Vehicle control history is not output A
Vehicle control history is output B



A

B

8.RECHECK VEHICLE CONTROL HISTORY
7.RECHECK FOR DTC
a.

Clear the DTCs.


b.

Reproduce the detection conditions of the recorded DTC.

HINT:

Refer to the flowchart of each diagnosis code for the diagnosis code detection condition.

Click hereEngine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DIAGNOSTIC TROUBLE CODE CHART




Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

8.RECHECK VEHICLE CONTROL HISTORY

B

8.RECHECK VEHICLE CONTROL HISTORY
a.

Using the GTS, clear the vehicle control history.


b.

Using the GTS, check for vehicle control history.


Result:
Result Proceed to
Vehicle control history codes are not output A
Vehicle control history codes are output B



A

B