Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM › from 2020.08
RM27T0E _51 Engine / Hybrid System _053696 CRUISE CONTROL _0332058 LANE DEPARTURE ALERT SYSTEM T

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM  PROBLEM SYMPTOMS TABLE  


NOTICE:
·

If the forward recognition camera is replaced with a new one it is necessary to perform forward recognition camera optical axis adjustment and clear the vehicle control history for each system.

HINT:

Perform forward recognition camera optical axis alignment with either "One time recognition" or "Sequential recognition". Refer to the following for clearing the vehicle control history.

One time recognition:Engine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (ONE TIME RECOGNITION)

Sequential recognition:Engine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (SEQUENTIAL RECOGNITION)


·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in the combination meter assembly will not match the information from the vehicle, and may cause a DTC to be output.



HINT:
·

If no problem symptoms are found when a DTC is output in the DTC check on the lane departure alert system, check each symptom by checking the suspected areas in the order they are listed.

·

Before performing failure diagnosis according to the following inspection points, check the forward recognition camera system power source circuit fuses and relays.



Symptom Suspected Area Link
The lane departure alert system does not operate at all Steering pad switch circuit Click here
Forward recognition camera adjustment
HINT:

Perform forward recognition camera optical axis alignment with either "One time recognition" or "Sequential recognition".


One time recognition:Click here
Sequential recognition:Click here
The LDA indicator light does not turn on or off even by operating the LDA switch Indicator circuit Click here
Steering pad switch circuit Click here
Forward recognition camera Click here
The lane departure alert system is not canceled even by operating the turn signals Data List/Active Test (Turn Switch) Click here
Turn signal switch circuit (for Halogen Headlight) Click here
Turn signal switch circuit (for LED Headlight) Click here
The lane departure alert system does not operate many times even when the white lines are visible Check conditions for operating/not operating Click here
Forward recognition camera adjustment
HINT:

Perform forward recognition camera optical axis alignment with either "One time recognition" or "Sequential recognition".


One time recognition:Click here
Sequential recognition:Click here
The lane departure alert system is operating but the system control status is not displayed on the multi-information display Data List/Active Test (LDA Control) Click here
Combination meter assembly Click here
The lane departure warning function is on but the buzzer does not sound even when straying from white line Combination meter assembly Click here