Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2020.08
RM27T0E _51 Engine / Hybrid System _053696 CRUISE CONTROL _0260748 DYNAMIC RADAR CRUISE CONTROL SYSTEM J

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  Cruise SET Indicator Light Circuit  


DESCRIPTION

The ECM illuminates the cruise SET indicator by sending request signals to the combination meter assembly via CAN communication. The cruise SET indicator illuminates when the dynamic radar cruise control system is controlling vehicle speed. If the cruise SET indicator is not operating correctly, check for CAN communication DTCs before troubleshooting this circuit.

CAUTION / NOTICE / HINT

CAUTION:

Observe the following items for safety reasons when using the GTS:

·

Before using the GTS, read the instruction manual.

·
A371909

Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.

·
A356953

When driving the vehicle for testing purposes, 2 people are required. One person should operate the GTS while the other drives the vehicle.



NOTICE:
·

Before replacing the ECM, refer to Service Bulletin.

·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.



PROCEDURE

1.PERFORM ACTIVE TEST USING GTS
a.

Perform "Active Test" according to the display on the GTS.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Meter Display 1 Multi-information display OFF or All -


Result:
Result Proceed to
The multi-information display in the combination meter assembly turns on according to the operation of the Active Test. A
The multi-information display in the combination meter assembly does not turn on according to the operation of the Active Test. B



A

2.READ VALUE USING GTS

B

2.READ VALUE USING GTS
a.

Read the Data List according to the display on the GTS.

i.

Radar Cruise1 (for 1GR-FE, 2TR-FE):

Powertrain > Radar Cruise1 > Data List
Tester Display Measurement Item / Range Normal Condition Diagnostic Note
-SET Switch -SET switch status / ON or OFF ON: -SET switch on
OFF: -SET switch off
-


ii.

Radar Cruise1 (for 1GD-FTV):

Powertrain > Radar Cruise1 > Data List
Tester Display Measurement Item / Range Normal Condition Diagnostic Note
-SET Switch -SET switch status / ON or OFF ON: -SET switch on
OFF: -SET switch off
-



Result:
Result Proceed to
The cruise SET indicator illuminates and turns off according to the operation of the cruise control main switch (-SET switch). A
The cruise SET indicator does not illuminate but the Data List item -SET Switch changes according to the operation of the cruise control main switch (-SET switch). B
The cruise SET indicator does not illuminate and the Data List item -SET Switch does not change according to the operation of the cruise control main switch (-SET switch). C



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPLACE COMBINATION METER ASSEMBLY

C