Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › from 2020.08
RM27T0E _58 Vehicle Interior _091549 PRE-COLLISION _0438246 PRE-COLLISION SYSTEM C

PRE-COLLISION  PRE-COLLISION SYSTEM  U041881  Invalid Data Received from Brake System Control Module Invalid Serial Data Received  


DESCRIPTION

·

The forward recognition camera receives signals from the skid control ECU (master cylinder solenoid) corresponding to the brake control status via the CAN communication line.

·

When a brake control system malfunction signal is received from the skid control ECU (master cylinder solenoid), the forward recognition camera outputs U041881.


DTC No. Detection Item DTC Detection Condition Trouble Area
U041881 Invalid Data Received from Brake System Control Module Invalid Serial Data Received Once 3 seconds elapse after turning the ignition switch to ON, the forward recognition camera receives a brake control system malfunction signal from the skid control ECU (master cylinder solenoid) for approximately 1 second or more.
·

Forward recognition camera

·

Vehicle stability control system



CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

·

When the forward recognition camera is replaced with a new one, make sure to perform beam axis adjustment for the forward recognition camera and clear the vehicle control history for each system.

HINT:

Forward recognition camera adjustment can be performed by using either "One Time Recognition" or "Sequential Recognition".

One Time Recognition:

Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (ONE TIME RECOGNITION)

Sequential Recognition:

Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (SEQUENTIAL RECOGNITION)




PROCEDURE

1.CHECK VEHICLE STABILITY CONTROL SYSTEM
a.

Check for DTCs.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>DTC CHECK / CLEAR

OK:

Electronically controlled brake system DTCs are not output.


HINT:

If U041881 is output in the pre-collision system, vehicle stability control system DTCs may also have been output. Check the vehicle stability control system first.



Result:
Proceed to
OK
NG



OK

REPLACE FORWARD RECOGNITION CAMERA

NG