Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM (for i-ART) › from 2020.08
RM27T0E _51 Engine / Hybrid System _053696 CRUISE CONTROL _0438249 CRUISE CONTROL SYSTEM(for i-ART) J

CRUISE CONTROL  CRUISE CONTROL SYSTEM(for i-ART)  Cruise Main Indicator Light Circuit  


DESCRIPTION

The ECM illuminates the cruise control indicator by sending indicator output demand signals to the combination meter assembly via CAN communication. The cruise control indicator illuminates when the cruise control system is turned on using the cruise control main switch (ON-OFF button). If a malfunction is detected, the cruise control indicator turns off and a warning message is displayed. The cruise control indicator circuit uses CAN communication. If the cruise control indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.

CAUTION / NOTICE / HINT

NOTICE:
·

Before replacing the ECM, refer to the Service Bulletin.

·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.



PROCEDURE

1.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Perform the Active Test according to the display on the GTS.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Meter Display 1 Multi-information display OFF or All -


Result:
Result Proceed to
The multi-information display in the combination meter assembly turns on according to the operation of the Active Test. A
The multi-information display in the combination meter assembly does not turn on according to the operation of the Active Test. B



A

2.READ VALUE USING GTS

B

2.READ VALUE USING GTS
a.

Enter the following menus: Powertrain / Cruise Control / Data List.


b.

Read the Data List according to the display on the GTS.

Powertrain > Cruise Control > Data List
Tester Display Measurement Item / Range Normal Condition Diagnostic Note
Cruise Indicator Cruise control indicator light signal / ON or OFF ON: Cruise control indicator illuminates
OFF: Cruise control indicator turns off
-


Result:
Result Proceed to
The cruise control indicator illuminates and turns off according to the operation of the cruise control main switch (ON-OFF button). A
The cruise control indicator does not illuminate but the Data List item Cruise Indicator changes according to the operation of the cruise control main switch (ON-OFF button). B
The cruise control indicator does not illuminate and the Data List item Cruise Indicator does not change according to the operation of the cruise control main switch (ON-OFF button). C



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPLACE COMBINATION METER ASSEMBLY

C