Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM (except i-ART) › from 2020.08
RM27T0E _51 Engine / Hybrid System _053696 CRUISE CONTROL _0438250 CRUISE CONTROL SYSTEM(except i-ART) J

CRUISE CONTROL  CRUISE CONTROL SYSTEM(except i-ART)  Cruise Main Indicator Light Circuit  


DESCRIPTION

·

The ECM turns on the cruise control indicator light by sending indicator output demand signals to the combination meter assembly using CAN communication.

·

The cruise control indicator light illuminates when the cruise control system has been turned on using the cruise control main switch (ON-OFF). If a malfunction is detected, the cruise control indicator light goes off and a warning message is displayed.

·

The cruise control indicator light circuit uses CAN communication. If the cruise control indicator light is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

·

Before replacing the ECM, refer to the Service Bulletin.



PROCEDURE

1.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

According to the display on the GTS, perform the Active Test.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Meter Display 1 Multi-information display OFF or All -

OK:

The multi-information display in the combination meter assembly turns off or completely on according to the GTS operation



Result:
Result Proceed to
OK A
NG B



A

2.READ VALUE USING GTS

B

2.READ VALUE USING GTS
a.

Enter the following menus: Powertrain / Cruise Control / Data List.


b.

Read the Data List according to the display on the GTS.

Powertrain > Cruise Control > Data List
Tester Display Measurement Item / Range Normal Condition Diagnostic Note
CCS Indicator M-CPU CRUISE main indicator (Main CPU) / ON or OFF ON: CRUISE main indicator light on
OFF: CRUISE main indicator light off
-


Result:
Result Proceed to
The indicator operates normally according to the on and off operations A
The GTS screen display changes from off to on, but the cruise control indicator light in the combination meter assembly does not illuminate B
The cruise control indicator light in the combination meter assembly does not illuminate and the GTS screen display does not change from off C



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPLACE COMBINATION METER ASSEMBLY

C