Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM (except i-ART) › from 2020.08
RM27T0E _51 Engine / Hybrid System _053696 CRUISE CONTROL _0438250 CRUISE CONTROL SYSTEM(except i-ART) J

CRUISE CONTROL  CRUISE CONTROL SYSTEM(except i-ART)  Cruise SET Indicator Light Circuit  


DESCRIPTION

·

The ECM turns on the SET indicator light by sending indicator output demand signals to the combination meter assembly using CAN communication.

·

The cruise control SET indicator light illuminates when the cruise control system is controlling vehicle speed.

·

The cruise control indicator light circuit uses CAN communication. If the cruise control indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.


CAUTION / NOTICE / HINT

CAUTION:

Observe the following items for safety reasons when using the GTS:

·
A356952

Before using the GTS, read the instruction manual.

·
A356953

Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.

·

When driving the vehicle for testing purposes, 2 people are required. One person should operate the GTS while the other drives the vehicle.



NOTICE:
·

Before replacing the ECM, refer to the Service Bulletin.

·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.



PROCEDURE

1.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

According to the display on the GTS, perform the Active Test.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Meter Display 1 Multi-information display OFF or All -

OK:

The multi-information display in the combination meter assembly turns off or completely on according to the GTS operation



Result:
Result Proceed to
OK A
NG B



A

2.READ VALUE USING GTS (SET/COAST SWITCH)

B

2.READ VALUE USING GTS (SET/COAST SWITCH)
a.

Enter the following menus: Powertrain / Cruise Control / Data List.


b.

Read the Data List according to the display on the GTS.

Powertrain > Cruise Control > Data List
Tester Display Measurement Item / Range Normal Condition Diagnostic Note
SET/COAST Switch -SET switch signal / ON or OFF ON: -SET switch on
OFF: -SET switch off
-


Result:
Result Proceed to
The indicator operates normally according to the on and off operations A
The GTS screen display changes from off to on, but the cruise control SET indicator light in the combination meter assembly does not illuminate B
The cruise control SET indicator light in the combination meter assembly does not illuminate, and the indication in the GTS screen display stays at OFF C



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPLACE COMBINATION METER ASSEMBLY

C