CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (except 5L-E)
| *A | Main Body ECU (Multiplex Network Body ECU) with 3 connectors | *B | for LHD |
| *C | for RHD | - | - |
| *1 | Main Body ECU (Multiplex Network Body ECU) | - | - |
| *A | Main Body ECU (Multiplex Network Body ECU) with 2 connectors | *B | for LHD |
| *C | for RHD | - | - |
| *1 | Main Body ECU (Multiplex Network Body ECU) | - | - |
Remove the main body ECU (multiplex network body ECU) from the driver side junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
Connect the driver side junction block assembly connectors.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| A-32 (IG) - Body ground | None - Body ground | IG power supply | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | |||
| A-31 (BECU) - Body ground | None - Body ground | Battery power supply | Always | 11 to 14 V |
| A-30 (ACC) - Body ground | None - Body ground | ACC power supply | Ignition switch ACC | 11 to 14 V |
| Ignition switch off | Below 1 V | |||
| A-11 (GND1) - Body ground | None - Body ground | Body ground | Always | Below 1 Ω |
Install the main body ECU (multiplex network body ECU).
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>INSTALLATION
Measure the voltage and pulse according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
|
*1: w/ Rear Fog Light *2: w/ Front Fog Light *3: for LHD *4: for RHD *5: w/ Automatic High Beam System *6: w/ Automatic Light Control System *7: w/ Daytime Running Light |
||||
| G216-23 (AHBI) - Body ground*5 | P - Body ground | Auto high beam switch signal input | Auto high beam switch on | Below 1 V |
| Auto high beam switch off | 11 to 14 V | |||
| G218-1 (DIM) - Body ground | P - Body ground | H-LP HI relay drive output | Ignition switch ON, headlight dimmer switch in high or high flash position | Below 1 V |
| Ignition switch ON, headlight dimmer switch not in high or high flash position | 11 to 14 V | |||
| G218-8 (A) - Body ground*6 | W - Body ground | Light control switch Auto position signal input | Light control switch in Auto position | Below 1 V |
| Light control switch not in Auto position | 11 to 14 V | |||
| G218-10 (HF) - Body ground | V - Body ground | Headlight dimmer switch high flash position signal input | Headlight dimmer switch in high flash position | Below 1 V |
| Headlight dimmer switch not in high flash position | 11 to 14 V | |||
| G218-12 (HEAD) - Body ground | SB - Body ground | Light control switch head position signal input | Light control switch in head position | Below 1 V |
| Light control switch not in head position | 11 to 14 V | |||
| G218-19 (CLTB) - G218-21 (CLTE)*6 | P - L | Automatic light control sensor power supply output | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V | |||
| G218-20 (CLTS) - Body ground*6 | R - Body ground | Automatic light control sensor signal input | Ignition switch off | Below 1 V |
| Automatic light control system operating | Pulse generation
(See waveform 1) |
|||
| G218-22 (TAIL) - Body ground | W - Body ground | Light control switch tail position signal input | Light control switch in tail or head position | Below 1 V |
| Light control switch not in tail or head position | 11 to 14 V | |||
| G218-23 (RFOG) - Body ground*1 | SB - Body ground | Fog light switch rear position input | Fog light switch in rear position | Below 1 V |
| Fog light switch off | 11 to 14 V | |||
| G218-24 (HU) - Body ground | LG - Body ground | Headlight dimmer switch high position signal input | Headlight dimmer switch in high flash position | Below 1 V |
| Headlight dimmer switch not in high flash position | 11 to 14 V | |||
| G218-26 (FFOG) - Body ground*2 | G - Body ground | Fog light switch front position input | Fog light switch in front position | Below 1 V |
| Fog light switch off | 11 to 14 V | |||
| 2M-26 - Body ground | LG - Body ground | Taillight drive output | Light control switch in tail or head position | Below 1 V |
| Light control switch off | 11 to 14 V | |||
| 2Q-31 - Body ground*3 | LG - Body ground | Taillight drive output | Light control switch in tail or head position | Below 1 V |
| Light control switch off | 11 to 14 V | |||
| 2N-9 - Body ground*4 | LG - Body ground | Taillight drive output | Light control switch in tail or head position | Below 1 V |
| Light control switch off | 11 to 14 V | |||
| 2M-17 (HRLY) - Body ground | GR - Body ground | H-LP LO relay drive output | Ignition switch ON, light control switch in head position | Below 1 V |
| Ignition switch ON, light control switch not in head position | 11 to 14 V | |||
| 2Q-11 - Body ground*1, *3 | G - Body ground | Rear fog light drive output | Light control switch in tail or head position, fog light switch off | Below 1 V |
| Light control switch in tail or head position, fog light switch in rear position | 11 to 14 V | |||
| 2P-11 - Body ground*1, *4 | G - Body ground | Rear fog light drive output | Light control switch in tail or head position, fog light switch off | Below 1 V |
| Light control switch in tail or head position, fog light switch in rear position | 11 to 14 V | |||
| 2M-19 - Body ground*2 | W - Body ground | Front fog light drive output | Light control switch in tail or head position, fog light switch off | Below 1 V |
| Light control switch in tail or head position, fog light switch in front position | 11 to 14 V | |||
| 2O-40 (DRLE) - Body ground*7 | P - Body ground | DRL relay drive output | Daytime running light on | Below 1 V |
| Daytime running light off | 11 to 14 V | |||
Waveform 1
| Item | Content |
|---|---|
| Terminal No. (Symbol) | G218-20 (CLTS) - Body ground |
| Tool Setting | 2 V/DIV., 10 ms./DIV. |
| Condition | Automatic light control system operating |
The communication waveform changes according to the surrounding brightness.
CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (for 5L-E)
| *A | for LHD | *B | for RHD |
| *1 | Main Body ECU (Multiplex Network Body ECU) | - | - |
Remove the main body ECU (multiplex network body ECU) from the driver side junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
Connect the driver side junction block assembly connectors.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| A-32 (IG) - Body ground | None - Body ground | IG power supply | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | |||
| A-30 (BECU) - Body ground | None - Body ground | Battery power supply | Always | 11 to 14 V |
| A-29 (ACC) - Body ground | None - Body ground | ACC power supply | Ignition switch ACC | 11 to 14 V |
| Ignition switch off | Below 1 V | |||
| A-11 (GND1) - Body ground | None - Body ground | Body ground | Always | Below 1 Ω |
Install the main body ECU (multiplex network body ECU).
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>INSTALLATION
Measure the voltage and pulse according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
|
*1: w/ Rear Fog Light *2: w/ Front Fog Light *3: for LHD *4: for RHD |
||||
| G64-15 (DIM) - Body ground | P - Body ground | H-LP HI relay drive output | Ignition switch ON, headlight dimmer switch in high or high flash position | Below 1 V |
| Ignition switch ON, headlight dimmer switch not in high or high flash position | 11 to 14 V | |||
| 2F-40 (HRLY) - Body ground | GR - Body ground | H-LP LO relay drive output | Ignition switch ON, light control switch in head position | Below 1 V |
| Ignition switch ON, light control switch not in head position | 11 to 14 V | |||
| G64-8 (HF) - Body ground | V - Body ground | Headlight dimmer switch high flash position signal input | Headlight dimmer switch in high flash position | Below 1 V |
| Headlight dimmer switch not in high flash position | 11 to 14 V | |||
| G64-29 (HEAD) - Body ground | SB - Body ground | Light control switch head position signal input | Light control switch in head position | Below 1 V |
| Light control switch not in head position | 11 to 14 V | |||
| G64-30 (TAIL) - Body ground | W - Body ground | Light control switch tail position signal input | Light control switch in tail or head position | Below 1 V |
| Light control switch not in tail or head position | 11 to 14 V | |||
| G64-23 (RFOG) - Body ground*1 | SB - Body ground | Fog light switch rear position input | Fog light switch in rear position | Below 1 V |
| Fog light switch off | 11 to 14 V | |||
| G64-5 (HU) - Body ground | LG - Body ground | Headlight dimmer switch high position signal input | Headlight dimmer switch in high flash position | Below 1 V |
| Headlight dimmer switch not in high flash position | 11 to 14 V | |||
| G64-27 (FFOG) - Body ground*2 | G - Body ground | Fog light switch front position input | Fog light switch in front position | Below 1 V |
| Fog light switch off | 11 to 14 V | |||
| 2F-7 - Body ground | LG - Body ground | Taillight drive output | Light control switch in tail or head position | Below 1 V |
| Light control switch off | 11 to 14 V | |||
| 2I-16 - Body ground*3 | LG - Body ground | Taillight drive output | Light control switch in tail or head position | Below 1 V |
| Light control switch off | 11 to 14 V | |||
| 2D-32 - Body ground*4 | LG - Body ground | Taillight drive output | Light control switch in tail or head position | Below 1 V |
| Light control switch off | 11 to 14 V | |||
| 2F-19 - Body ground*1 | GR-L - Body ground | Rear fog light drive output | Light control switch in tail or head position, fog light switch in rear position | Below 1 V |
| Light control switch in tail or head position, fog light switch off | 11 to 14 V | |||
| 2F-9 - Body ground*2 | W - Body ground | Front fog light drive output | Light control switch in tail or head position, fog light switch off | Below 1 V |
| Light control switch in tail or head position, fog light switch in front position | 11 to 14 V | |||
CHECK COMBINATION METER ASSEMBLY
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>TERMINALS OF ECU
CHECK FORWARD RECOGNITION CAMERA (w/ Automatic High Beam System)
Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA SYSTEM>TERMINALS OF ECU