22204
1.CLEAN INTAKE MASS AIR FLOW METER SUB-ASSEMBLY
Do not loose a screw for fixing intake air flow meter sub-assembly. The resin of air cleaner cap sub-assembly would be damaged by repetition of fasten and loose more than 10 times.
Disconnect the mass air flow meter sub-assembly connector and detach the 2 harness clamps.
Detach the 4 clips.
Loosen the hose clamp and remove the air cleaner cap sub-assembly.
Perform air blowing:
| *1 | Intake Air Flow Meter Sub-assembly |
| *a | Air Gun |
| *b | 10 mm (0.3937 in.) |
| *c | Air Flow Meter Exit Hole |
Do not touch the tip of the air gun nozzle to the air flow meter, and do not insert the tip of the air gun nozzle into the air flow meter exit hole.
| *a | Intermittently |
| *b | 3 to 6 seconds |
| *c | 1 second |
| *d | On |
| *e | Off |
Intermittently air blow the intake air flow meter sub-assembly exit hole with a pressure of approximately 392 to 981 kPa (4.0 to 10.0 kgf/cm2, 57 to 142 psi) more than 10 times over 30 seconds or more.
Attach the 4 clips to install the air cleaner cap sub-assembly.
Tighten the hose clamp.
Connect the mass air flow meter connector and attach the 2 wire harness clamps.
22204
2.INSPECT INTAKE MASS AIR FLOW METER SUB-ASSEMBLY
Read the value using the GTS (Mass Air Flow Sensor).
Perform the inspection of the intake mass air flow meter sub-assembly while it is installed to the air cleaner cap sub-assembly (installed to the vehicle).
Connect the GTS to the DLC3.
Start the engine.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Data List / Mass Air Flow Sensor.
Wait for 30 seconds, and read the value on the GTS.
w/o Urea SCR System: (See page Engine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM>DATA LIST / ACTIVE TEST)
w/ Urea SCR System: (See page Engine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ Urea SCR System)>DATA LIST / ACTIVE TEST)
If the result is not as specified, replace the intake mass air flow meter sub-assembly.
If the result is within the specified range, inspect the intake mass air flow meter sub-assembly (See page Engine / Hybrid System>1GD-FTV (ENGINE CONTROL)>MASS AIR FLOW METER>INSPECTION).