Home › Steering › STEERING COLUMN › STEERING LOCK SYSTEM › from 2020.08
RM27T0E _55 Steering _053718 STEERING COLUMN _0260954 STEERING LOCK SYSTEM L

STEERING COLUMN  STEERING LOCK SYSTEM  PRECAUTION  


PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL


NOTICE:
·

After the engine switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When disconnecting and reconnecting the battery

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART





PRECAUTIONS WHEN CHECKING FOR DTCS


a.

When the cable is disconnected from the negative (-) battery terminal, the DTCs stored in the steering lock ECU (steering lock actuator or upper bracket assembly) are cleared. Be sure to record any output DTCs immediately.


b.

When using the GTS with the engine switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select the Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry & Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.



PRECAUTION FOR REGISTRATION


a.

If replacing any of the following parts, refer to the Service Bulletin.

i.

Certification ECU (smart key ECU assembly)


ii.

Steering lock ECU (steering lock actuator or upper bracket assembly)


iii.

Electrical key transmitter sub-assembly


iv.

ID code box (immobiliser code ECU)


v.

Main body ECU (multiplex network body ECU)


vi.

ECM




PRECAUTIONS FOR STEERING LOCK/UNLOCK FUNCTION


a.

After turning the engine switch off and opening and closing any of the doors, the steering wheel will be locked due to the steering lock function. Operating the engine switch again automatically cancels the steering lock function.


b.

To prevent the steering lock motor from overheating, the motor operation may be suspended if the steering is locked and unlocked repeatedly in a short period of time. In this case, refrain from operating the engine switch. After about 10 seconds, the steering lock motor will resume functioning.