Home › Engine / Hybrid System › 1GD-FTV (STARTING) › STARTER (w/ Stop And Start System) › from 2020.08
RM27T0E _51 Engine / Hybrid System _053695 1GD-FTV STARTING _0442003 STARTER(w/ Stop And Start System) A

1GD-FTV STARTING  STARTER(w/ Stop And Start System)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the starter assembly removal/installation are shown below.

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Correction of steering angle neutral point Multi-terrain monitor system (Click here)
Starter assembly
NOTICE:

When the starter assembly is replaced, "ST relay" and "ST No. 2 relay" must be also replaced.


Clear the number of starter operations Stop and start system (Click here)
Automatic transmission fluid ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly. (Click here)

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane departure alert system Drive the vehicle straight ahead at 40 km/h (25 mph) or more for 10 seconds or more. (Click here)
Pre-collision system
Lighting system (EXT) (for LED Headlight)
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Vehicle stability control system (for Hydraulic brake booster) Drive the vehicle straight ahead at 40 km/h (25 mph) or more for at least 10 seconds. (Click here)


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

When the starter assembly is replaced, "ST relay" and "ST No. 2 relay" must be also replaced.


Hide 28100 3.REMOVE STARTER ASSEMBLY

a.
A477828

Disconnect the 2 starter connectors.


b.

Remove the nut and disconnect the starter wire.


c.

Detach the clamp.


d.

Remove the bolt and starter assembly.