Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Check the battery voltage.
11 to 14 V
| Result | Proceed to | |
|---|---|---|
| OK | A | |
| NG | for 1GR-FE | B |
| for 1GD-FTV | C | |
A
B
C
Turn the ignition switch off.
Disconnect the G53 and G54 4 wheel drive control ECU connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G53-21 (+B) - Body ground | Always | 11 to 14 V |
| G54-4 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector
(to 4 Wheel Drive Control ECU) |
OK
NG
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G54-10 (GND) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to 4 Wheel Drive Control ECU) |
OK
(See pageDrivetrain>AXLE AND DIFFERENTIAL>DIFFERENTIAL SYSTEM (w/ Differential Lock)>PROBLEM SYMPTOMS TABLE)
NG