Home › Power Source / Network › 1GD-FTV (BATTERY / CHARGING) › CHARGING SYSTEM › from 2020.08
RM27T0E _57 Power Source / Network _053727 1GD-FTV BATTERY / CHARGING _0261025 CHARGING SYSTEM C

1GD-FTV BATTERY / CHARGING  CHARGING SYSTEM  P160200  Deterioration of Battery Low Capacity  


DESCRIPTION

The ECM determines the battery status according to the voltage of the BATT terminal while the engine is running (not cranking).

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory Note
P160200 Deterioration of Battery Low Capacity Battery capacity is low for 10 seconds or more when the engine is running (not cranking).
(1 trip detection logic)
·

Battery

·

Wire harness or connector


Charge warning light does not come on DTC stored SAE Code: P1602

WIRING DIAGRAM

A474995E01
0.896,1.844 1.5,2.073 0.604,0.229 10 false Battery 0.781,1.135 1.385,1.365 0.604,0.229 10 false 70A FL 2.406,0.875 3.729,1.25 1.323,0.375 10 false EFI MAIN NO. 1 5.771,0.698 6.375,0.927 0.604,0.229 10 false BATT 5.792,1.635 6.396,1.865 0.604,0.229 10 false E1 2.677,0.531 2.813,0.76 0.135,0.229 10 false 1 2.917,0.531 3.052,0.76 0.135,0.229 10 false 2 5.323,0.708 5.813,0.917 0.49,0.208 10 false G184 5.479,0.49 5.615,0.719 0.135,0.229 10 false 1 5.49,1.448 5.625,1.677 0.135,0.229 10 false 5 5.333,1.635 5.771,1.875 0.438,0.24 10 false G185 6.031,2.24 6.635,2.469 0.604,0.229 10 false ECM

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


HINT:

If any DTCs other than P160200 are output, troubleshoot those DTCs first.


PROCEDURE

1.CHECK CHARGING SYSTEM

Result:
Result
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)

NG

REPAIR OR REPLACE CHARGING SYSTEM

2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)
a.

Disconnect the ECM connector.


b.
A444789C05
0.094,0.917 0.594,1.167 0.5,0.25 0.563,1.844 1.229,1.01 true 0.104,0.115 0.417,0.271 0.313,0.156 10 false *a 0.188,0.958 0.958,1.135 0.771,0.177 10 false G184 0.167,1.823 0.698,2.052 0.531,0.229 10 false BATT
*a Front view of wire harness connector
(to ECM)


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
G184-1 (BATT) - Body ground Always 11 to 14 V



Result:
Result
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR