When using a vise, do not overtighten it.
When installing the parts indicated by arrows, coat them with power steering fluid (See page Steering>POWER ASSIST SYSTEMS>VANE PUMP (for 2TR-FE)>COMPONENTS).
1. PRECAUTION
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
16361A
3.REMOVE FAN AND GENERATOR V BELT
44412
4.DISCONNECT RETURN HOSE
Remove the clip and disconnect the hose.
44410
5.DISCONNECT PRESSURE FEED TUBE ASSEMBLY (w/ VSC)
Disconnect the 2 connectors.
Remove the union bolt and disconnect the pressure feed tube from the vane pump.
Remove the gasket from the pressure feed tube.
44410
6.DISCONNECT PRESSURE FEED TUBE ASSEMBLY (w/o VSC)
Remove the union bolt and disconnect the pressure feed tube from the vane pump.
Remove the gasket from the pressure feed tube.
44310
7.REMOVE VANE PUMP ASSEMBLY (w/ VSC)
Remove the 2 bolts and vane pump.
44310
8.REMOVE VANE PUMP ASSEMBLY (w/o VSC)
Disconnect the connector from the power steering oil pressure switch.
Remove the 2 bolts and vane pump.