The center airbag sensor consists of the airbag sensor, safing sensor, drive circuit, diagnosis circuit, ignition control, etc.
If the center airbag sensor receives signals from the airbag sensor, it determines whether the SRS should be activated.
DTC B1000 is stored when a malfunction is detected in the center airbag sensor.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1000 | A center airbag sensor malfunction. | Center airbag sensor |
When a trouble code is output simultaneously with B1000, repair the malfunction indicated by the other code first.
After replacing the center airbag sensor, refer to initialization (See page General>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>WORK PROCEDURE).
Turn the ignition switch to ON, and wait for at least 60 seconds.
Check for DTCs (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC B1000 is output | A |
| DTC B1000 and other DTCs are output | B |
A
B
(See pageVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSTIC TROUBLE CODE CHART)