Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RECEIVER (for 3 Door) › from 2020.08
RM27T0E _53 Suspension _053710 TIRE PRESSURE MONITORING _0327504 TIRE PRESSURE WARNING RECEIVER(for 3 Door) A

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING RECEIVER(for 3 Door)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the tire pressure warning ECU and receiver removal/installation are shown below.

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Correction of steering angle neutral point Multi-terrain monitor system (Click here)

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane departure alert system Drive the vehicle straight ahead at 40 km/h (25 mph) or more for 10 seconds or more. (Click here)
Pre-collision system
Lighting system (EXT) (for LED Headlight)
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Vehicle stability control system (for Hydraulic brake booster) Drive the vehicle straight ahead at 40 km/h (25 mph) or more for at least 10 seconds. (Click here)



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 3.REMOVE REAR NO. 1 SEAT ASSEMBLY (w/ Rear No. 1 Seat)

a.

b.

Hide 64910M 4.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

Hide 58574A 6.REMOVE REAR FLOOR MAT REAR SUPPORT PLATE

Hide 64725D 9.REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

Hide 64937A 10.REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/o Tonneau Cover)

Hide 64712F 11.REMOVE FRONT DECK SIDE TRIM COVER (w/ Tonneau Cover)

Hide 64740C 14.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

Hide 62640P 15.REMOVE REAR QUARTER TRIM PANEL ASSEMBLY LH

Hide 897B0 16.REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER

a.
C384985

Disconnect the connector.


b.

Remove the bolt and tire pressure warning ECU and receiver.