Home › Engine / Hybrid System › 1GR-FE (FUEL) › FUEL PRESSURE REGULATOR › from 2020.08
RM27T0E _51 Engine / Hybrid System _053667 1GR-FE FUEL _0260544 FUEL PRESSURE REGULATOR A

1GR-FE FUEL  FUEL PRESSURE REGULATOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the fuel pressure regulator assembly removal/installation are shown below.

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Correction of steering angle neutral point Multi-terrain monitor system (Click here)

HINT:

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane departure alert system Drive the vehicle straight ahead at 40 km/h (25 mph) or more for 10 seconds or more. (Click here)
Pre-collision system
Lighting system (EXT) (for LED Headlight)
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Vehicle stability control system (for Hydraulic brake booster) Drive the vehicle straight ahead at 40 km/h (25 mph) or more for at least 10 seconds. (Click here)



PROCEDURE

Hide 1. DISCHARGE FUEL SYSTEM PRESSURE

a.

Discharge the fuel system pressure (See page Engine / Hybrid System>1GR-FE (FUEL)>FUEL SYSTEM>PRECAUTION).


Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 17129 4.REMOVE INTAKE AIR SURGE TANK

a.

Hide 23802B 5.DISCONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY

Hide 23280 6.REMOVE FUEL PRESSURE REGULATOR ASSEMBLY

a.

Disconnect the vacuum hose.


b.
A223049

Remove the 2 bolts and fuel pressure regulator.


c.

Remove the O-ring from the fuel pressure regulator.