Home › Engine / Hybrid System › 1GR-FE (FUEL) › FUEL FILTER › from 2020.08
RM27T0E _51 Engine / Hybrid System _053667 1GR-FE FUEL _0260546 FUEL FILTER A

1GR-FE FUEL  FUEL FILTER  REPLACEMENT  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the fuel filter assembly removal/installation are shown below.

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Correction of steering angle neutral point Multi-terrain monitor system (Click here)

HINT:

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane departure alert system Drive the vehicle straight ahead at 40 km/h (25 mph) or more for 10 seconds or more. (Click here)
Pre-collision system
Lighting system (EXT) (for LED Headlight)
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Vehicle stability control system (for Hydraulic brake booster) Drive the vehicle straight ahead at 40 km/h (25 mph) or more for at least 10 seconds. (Click here)



PROCEDURE

Hide 1.DISCHARGE FUEL SYSTEM PRESSURE

a.

Discharge the fuel system pressure (See page Engine / Hybrid System>1GR-FE (FUEL)>FUEL SYSTEM>PRECAUTION).


Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 23271F 4.DISCONNECT FUEL HOSE

a.

Disconnect the hose from the clamp.


b.

Hide 77251B 5.DISCONNECT FUEL MAIN TUBE

a.
A224400

Disconnect the fuel main tube (See page Engine / Hybrid System>1GR-FE (FUEL)>FUEL SYSTEM>PRECAUTION).


Hide 23300J 6.REMOVE FUEL FILTER ASSEMBLY

a.
A224401

Remove the 3 bolts and fuel filter.


Hide 23300J 7.INSTALL FUEL FILTER ASSEMBLY

a.

Install the fuel filter with the 3 bolts.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)


Hide 77251B 8.CONNECT FUEL MAIN TUBE

a.

Connect the fuel main tube (See page Engine / Hybrid System>1GR-FE (FUEL)>FUEL SYSTEM>PRECAUTION).


Hide 23271F 9.CONNECT FUEL HOSE


b.

Connect the hose to the clamp.


Hide 10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 11. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART